Xrocker GRIP-CON Manual De Instrucciones página 4

ENG
Macro Programming:
A. Set Macro Function:
To set a macro button, with the controller turned on, press the
Macro button for 3 seconds and then the LED indicator will flash
slowly and start Macro programming mode. Release "Macro"
button, press the button combination that you would like to record,
then press the macro button again to set it.
Remember, this macro setting process will also record the time
taken between button presses. If the game requires a quick button
combination press then you will need to record the buttons at the
same speed!
B. Clear Macro function:
To clear, simply press the Macro button for 5 seconds. The LED
indicator will light up, letting you know that the macro setting is
cleared.
Turbo Function:
Press the buttons that you like to set as turbo at the same time as
the Turbo button on the Grip-con controller. The LED indicator will
flash to show this is working. To clear, simply repeat the process to
delete the setting.
Buttons supported by the Turbo function: A/B/X/Y/L/R/ZL/ZR
3. How to remove Grip-Con from Switch™ devices
Find the "remove" button on the back of Grip-Con and slide Grip-
Con from bottom to top while holding down the Console. Release
the "remove" button when the Grip-con completely disconnects
from the device.
4. Re-connection and wake up function
To reconnect the Grip-Cons from sleep mode, simply press the
HOME and CAPTURE button to wake both Grip-cons up.
console wake up function is only available when the Grip-Cons are
connected to the console (Handheld Mode) simply press the HOME
button for 1 second to wake up the console.