Black and Decker FSMH1321 Manual De Instrucciones página 12

Ocultar thumbs Ver también para FSMH1321:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 55
ENGLISH
SteaMitt
TM
Your BLACK+DECKER
SteaMitt
TM
sanitising and cleaning tiles, work tops, kitchen surfaces and
bathroom surfaces. This appliance is intended for indoor
household use only.
Attaching the SteaMitt
steam unit
Warning! Inspect the seal on the steam nozzle and hose
before each use. If the seal is missing or damaged then
please contact your nearest authorised repair agent. Do not
use the appliance. Inspect the seal on the SteaMitt
hose If the seal is missing, damaged or any steam is escaping
then please contact your nearest authorised repair agent.
Do not use the appliance. Ensure there is no blockage or
impedence in the SteaMitt
TM
are detected then please contact your nearest authorised
repair agent. Do not use the appliance.
Fitting a cleaning pad to the
Warning! Ensure there is no blockage or impedence in
the steam release vents If any are detected then please
contact your nearest authorised repair agent. Do not use the
appliance.
Fit the cleaning pad (27) to the SteaMitt
u
attaching the 'loop' velcro strips (27a) on the upper side
of the cleaning pad, to the 'hook' velcro pads (25a) on the
underside of the SteaMitt
Warning! The SteaMitt
should not be used without fitting a
TM
cleaning pad.
Note: The SteaMitt
accommodates 4 types of cleaning pads
TM
of varying thickness. Scouring pad (for use on tough stains
and non delicate surfaces), Bathroom pad (for use on taps
and other moulded bathroom surfaces), Standard pad (for use
on all larger surfaces) and Polishing pad (for use on delicate
surfaces).
@
Warning! Always use the SteaMitt
figure M, with your hand inside the protective glove.
Warning! Never attempt to use the SteaMitt
@
gripping it externally as shown in figure N.
This will result in scalding.
@
Warning! Avoid using the SteaMitt
as shown in figure O.
Warning! Should a problem occur during use,
@
use the quick release tab to quickly remove the
SteaMitt
from your hand as shown in figure P.
TM
Warning! Do not use the SteaMitt
@
such as windows as damage may be caused by the
sudden change in temperature.
@
Warning! Never point or direct the mitt at yourself
or any other person.
12
(Original instructions)
has been designed for
TM
hose to the hand held
TM
and
TM
hose or attachment hose. If any
SteaMitt
(Fig. L)
TM
(25) by
TM
(4). Press down firmly.
TM
as shown in
TM
by
TM
in tight corners
TM
on cold glass,
TM
Note:
It is recommended that the SteamMitt be used in
setting 1 to avoid the pad becoming too wet.
Use
Important! This unit will kill 99.9% of bacteria and germs
when used in accordance with the instructions in this manual
and with the micro fibre pads fitted and a continuous run time
of 90 seconds.
Switching on and off
To switch the appliance on, press the ON/Off switch (1).
u
It takes approximately 15 seconds for the steam mop to
heat up.
To switch the appliance off, press the ON/Off switch (1).
u
Note: always have your hand inside the SteaMitt
press the steam button.
Caution! Never leave the steam mop in one spot on any
surface for any period of time.
Always place the steam mop with the handle (8) supported in
the upright position when stationary and make sure the steam
mop is turned off when not in use.
Caution! Always empty the steam mop after use.
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
Autoselect
Technology (Fig. R)
TM
This steam mop is fitted with an Autoselect
shows various cleaning applications. They are used to select
the correct operating mode for your particular cleaning
operation.
Using Autoselect
, choose from one of the following
TM
applications by turning the Autoselect
required setting is selected.
Setting
Mop
Wood/Laminate
Tiles/Vinyl
Stone/Marble
The steam mop will select the correct volume of steam
required for your particular cleaning operation.
Note: Always check you are using the correct setting before
using your steam mop.
Steam Burst (Fig. C1) (only available with units
FSMH1310SM, FSMH13151SM, FSMH1321J,
FSMH1321JMD, FSMH1321JSM)
The floor head (12a) is equipped with a steam burst pedal to
aid in the removal of stubborn marks and stains.
before you
TM
dial (2) which
TM
dial (2) until the
TM
Hand held
Low steam flow
Medium steam flow
 
High steam flow
  

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido