Operation Of The Monitor - Mobiclinic ATLAS Manual De Instrucciones

EN
STEP 7
Please connect the pulse
wire (53) of computer(40)
and pulse wire (50) of fixed
handlebar(45).
Put the right batteries into
the battery case. Assemble
the computer (40)and front
post (37)with Screw M5*10
(39) and end plug,then tigh-
ten them with a wrench.

6. Operation of the monitor

MODE - Press down to select functions. Press down to reset time, distance and calo-
ries for 2 seconds.
SCAN: Press the MODE button until "SCAN" appears, the monitor will rotate through
the following functions: time, speed, distance, calories and pulse, each display will be
held for 6 seconds.
TIME: Counts the total time from the start of the exercise to the end.
SPEED: Displays the current speed.
DISTANCE / CALORIES: Counts distance / calories from the start of the exercise to the
end.
PULSE: Measures heart rate. Hold both heart rate sensors in both hands to measure
heart rate.
Note: During the process of pulse measurement, due to the jamming of the contacts,
the measurement value may be higher than the virtual pulse rate for the first 2~3
seconds, then it will return to the normal level. The measurement value cannot be
considered as the basis for medical treatment.
NOTE ：
1. If the battery symbol on the display is illuminated,
please replace the battery.
2. The monitor will automatically turn off if no signal is
received after 2 minutes and will automatically turn on
when it starts to exercise the input button signal.
3. When you stop exercising for 4 seconds, the display
will stop calculating and a "STOP" will be shown on the
display. When you start exercising, the display will start
calculating automatically and the "STOP" will disappear.
8
SCAN
TIME
SPEED
FUNC-
DISTANCE
TION
CALORIES
PULSE
BATTERY TYPE
OPERATING TMP.
STORAGE TMP.
AAA
X1
Every 6 seconds
0:00 ~ 99:59
0.0 ~ 99.9 KM/H (MILE/H)
0.00 ~ 99.00 KM (MILE)
0.0 ~ 999.9 CAL
60 ~ 240 BPM
2x AA o UM - 3
0ºC ~ +40ºC
-10ºC ~ +60ºC