Troubleshooting - Homelite UT41120 Manual Del Operador

PRObLEM
Lines will not advance when
using the Auto Feed Head:
Grass wraps around driveshaft
housing and string head:
Motor fails to start when
switch trigger is depressed.

TROUbLEShOOTINg

POSSIbLE cAUSE
1. Lines are welded to themselves.
2. Not enough string on spool.
3. Lines are worn too short.
4. Lines are tangled on spool.
1. Cutting tall grass at ground level.
1. Power cord is not plugged in or
connection is loose.
2. Household circuit breaker is
tripped.
CALL US FIRST
For any questions about operating or maintaining your product,
call the Homelite
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
Page 11 — English
SOLUTION
1. Lubricate with silicone spray.
2. Install more line. Refer to Line Replacement
earlier in this manual.
3. Pull both lines while pressing button.
4. Remove lines from spool and rewind. Refer to
Line Replacement earlier in this manual.
1. Cut tall grass from the top down to prevent
wrapping.
1. Plug in the power cord.
2. Check circuit breaker.
Help Line!
®