LUND Running Board Bracket Kit 2015-16 Ram 1500 Instrucciones De Instalación página 3

Installation Steps
If the Middle Bracket mounting location has an OPEN HOLE (no threads) in the rocker panel: Skip to Step 6
If the Middle Bracket mounting location has a THREADED HOLE in the rocker panel: Repeat Steps 2-3.
4
If the Rear Bracket mounting location has a threaded hole in the rocker panel, repeat Steps 2-3. NOTE: Do NOT fully tighten at
(2) bolts with (2) washers
and (2) nuts installed in
pinch weld
5
If the Middle and Rear mounting locations have open holes (not
threaded), remove tape to expose another hole above the rocker
panel mounting holes.
6
NOTE: Actual application may vary slightly from illustrations.
NOTE: Do NOT fully tighten at this time.
Bolt with washer
in upper bracket
hole (threaded),
into rocker panel
Middle Bracket
Fig. 6
Fig. 4
this time. Skip to Step 12.
Fig. 5
Bend (1) Plastic Insert 90°, a half an inch from the end
or
NOTE: The small or large plastic inserts are used to keep the
bolt plate from falling inside the rocker. The installer should
choose the plastic insert that is most suitable for the particu-
7
lar vehicle (all of the kits will come with both small and large
Page 3 of 5
(2) bolts with (2) washers
and (2) nuts installed in
pinch weld
Bolt with washer
in upper bracket
hole (threaded),
into rocker panel
Rear Bracket
as shown.
Fig. 7
plastic inserts).