Starting The Unit - WOOD'S DS-40FS Manual

OPERATING INSTRUCTIONS
1. Humidity control switch
2. Air outlet
3. Indicator lamp
4. Panel
5. Handle cover
6. Air filter
7. W ater tank
8. Wheel leg
3
CONTROL PLATE DESCRIPTION
OPERATION INSTRUCTION

Starting the unit

1. Firstly, turn the humidity control switch to the "OFF" position.
2. Plug in the dehumidifier.
3. Turn on the humidity control switch(to right side) and turn the same switch
to the reading of the desired humidity(60% in general as shown on
position"6").
Turning off the unit
1. Turn the humidity control switch to the left side to the "OFF" position and
the power supply is cut off and the unit stops in operation.
2. If the dehumidifier is not in use for a long time, please disconnect the
power cord plug from the outlet.
PRECAUTIONS
1. The dehumidifier shall not operate if the humidity setting is higher than the
ambient humidity.
2. Drain the water in the water storage tank when the water in the tank is full
and the water level indicator lamp illuminates red. Reinsert the
empty water tank back to its position, so the unit can continue its operation
and the indicator lamp illuminates blue.
3. When the unit stops, you have to wait for 3 minutes before you can restart
the unit to protect the compressor from damage.
4