Electrical Connection - LAVOR Pro Michigan LP 1211 Manual Del Usuario

EN
only for a few minutes so that any dirt is vented
from the delivery outlet.

ELECTRICAL CONNECTION

Check that the mains voltage is the same as
that of your machine, indicated on the techni-
cal data plate. Your electrical system must be
constructed by qualified technicians capable of
working in accordance with the requirements
of the regulations in force (earth connection,
fuses, differential security breaker, etc).
In case of failure to comply with one of the
regulations stated above, the manufacturer
declines all responsibility for the staff and
provides no warranty.
IMPORTANT: Regarding three-phase motors,
pay attention to the connection of the electric
cable to the plug (see electric diagram).
START-UP
(see pict. 4)
Switch on the machine by pressing the switch
and leave it to run for a few minutes to elimi-
nate any dirt and air bubbles from the water
circuit, then switch it off, connect the high
pressure line to the spray gun and fit the spray
rod.
When the machine is running again, check that
the jet is even; otherwise, clean the nozzle to
remove any dirt. Wait a few seconds for the op-
erating pressure to be reached, then operate
the gun for two or three short bursts.
> LANCE ASSEMBLY
(see pict. 3)
> DETERGENT SUCTION
Fill up the detergent tank with the suggested
products, suitable for the kind of washing to
be carried out (pict1, pos.7).
• CAUTION: Make use only of liquid
detergent, do not absolutely use acid or too
much alkaline products. We suggest you to
make use of our products, which have been
studied for the use with washer machines.
• CAUTION: For proper use of the tank, do not
introduce flammable or chemically harsh
substances.
The adjusting head allow you to select water
jet at low and high pressure. Pressure can be
adjusted by acting on nozzle knob (see pict.4):
ref. "B" means low pressure, "A" means high
pressure. The selection of low or high pressure
shall be carried out with gun in closed posi-
tion. The detergent suction is automatic when
the adjusting head of the lance is positioned
for low pressure operation. When you start the
machine, the mixing of the detergent with the
water is automatic at the water passage.
> APPLIANCES PROVIDED WITH THERMAL
VALVE (OPTIONAL)
This device enables the machine's by-pass op-
eration through automatic water discharge
whenever it reaches a temperature of nearly
60°C and cooling working components.
• CAUTION: appliances that are not provided
with this disposal must not operate for more
than 2 minutes with released gun. Recycled
water raises its temperature remarkably
causing great damages to the pump.
> GUN SAFETY DEVICE
Whenever the machine has to be stopped, it is
important to engage the safety catch (pict.5,
pos.S) on the gun so that it cannot be operated
accidentally.
> MAINTENANCE
• XX WARNING: the machine shall be
disconnected from its power source, by
removing the plug from the socket-outlet,
during cleaning or maintenance and when
replacing spare parts .
CHECKING THE PUMP OIL LEVEL
Check the oil level periodically. The oil must
be changed for the first time after 50 working
hours, with subsequent changes every 500
hours. Use synthetic oil SAE 20/30 (0,8 Kg).
CHECKING THE WATER INTAKE FILTER
Inspect and clean the water intake filter (pict 5,
pos.6)) on the intake union periodically. This is
important to prevent fouling which may impair
operation of the pump.
18