Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
The appliance is intended only for domestic use, not for professional use.
The following description is associated with the image on page 2:
1.
Lid
2.
Limescale filter
3.
Glass jug
4.
Base
5.
Handle
6.
Auto Start Button
1.
Unpack the device and remove all packaging parts.
2.
Clean the jug kettle before using for the first time (see 'Cleaning and maintenance').
Using the device as a kettle
1.
Remove the lid (1), fill the glass jug (3) with the desired amount of water, replace the lid and place the
glass jug on the base (4) and plug in the mains plug.
2.
This appliance must be connected to an earthed mains socket.
3.
If necessary, set the desired temperature with the Temperature + / - Buttons (11) and then press the
On/Off Button (10).
When it reaches the set temperature, the device emits 3 signals in quick succession. You can now take
the glass jug by the handle (5) off the base and pour out the hot water. After use, remove the plug from the
wall socket.
WARNING:
The hot water or hot parts can cause severe burns. Always pick up the glass jug by the handle.
Using the appliance as a tea maker
1.
Remove the lid, pull the tea basket, using the small ring, from the lift and fill the glass jug with the
desired amount of water.
2.
Open the tea basket and fill it with the desired amount of loose-leaf tea (or a tea bag). The amount
depends on your personal preference (approx. 1 scoop of loose-leaf tea per 250 ml of water). Close
the tea basket again and place it back on the lift. Close the lid on the glass jug, place the glass jug on
the base and plug in the mains plug.
3.
Now select one of the pre-sets with the Tea Type Selection Button (8). Each pre-set has its own
temperature and infusion time.
4.
Now press the On/Off Button (10).
When it reaches the pre-set temperature, the tea basket will automatically sink into the hot water.
When it reaches the pre-set infusion time, the tea basket will rise again, and the device will give 3 signals
in quick succession. You can now take the glass jug by the handle off the base and pour the tea. After use,
remove the plug from the wall socket.
You can deviate from the pre-sets by setting your own temperature and/or your own infusion time. To do this,
use the Temperature + / - Buttons and the Infusion Time + / - Buttons.
Using the auto start function
1.
Press and hold the Auto Start Button (6) until the display starts flashing.
2.
Use the Temperature + / - Buttons to set the current time.
3.
Use the Infusion Time + / - Buttons to set the delay time in 30-minute increments. You can set the
device to start automatically from 30 minutes to 10 hours.
4.
Confirm with the On/Off Button.
WARNING:
If the auto-start function is used, you must fill the appliance with sufficient water and tea beforehand.
Using the keep warm function
Press the Keep Warm Button (7) before, during or after the brewing process to ensure that the tea is kept
warm for a maximum of 60 minutes.
Overheating protection
The device is equipped with an overheating safety feature. This switches the appliance off automatically if it
is switched on without or with too little water. The device must then cool down for at least 10 minutes before
it can be used again.
7.
Keep Warm Button
8.
Tea Type Selection Button
9.
Tea Strength Selection Button
10. On/Off Button
11. Temperature + / - Buttons
12. Infusion Time + / - Buttons
13
EN
Publicidad
