Intended Use; Identification Plate - Wolf Garten LYCOS 40/480 V Instrucciones De Funcionamiento Originales

EN
¾ Store the device in a safe, dry location out of
the reach of children.
¾ Do not repair the device yourself; it must be
repaired by a qualified expert or workshop.
General safety information
¾ Never use a device with damaged or missing
guards or covers. They must be repaired or
replaced by a qualified expert or workshop.
¾ Spare parts must meet the requirements of
the manufacturer. Therefore use only original
spare parts or spare parts approved by the manu-
facturer. During replacement, always observe the
supplied fitting instructions and first remove the
power pack.
¾ Repairs must only be performed by a qualified
technician or service centre.
¾ The device must not be used for purposes
other than those intended because of the risk
of bodily injury to the user or other persons.

Intended use

This device is designed exclusively for use:
- as a leaf vacuum/blower around the outside of the
house and in the garden
- in accordance with the descriptions and safety
information given in this instruction manual.
Any other use is classed as incorrect use.
The user shall be liable for any damage arising from
incorrect use.
Incorrect/abnormal use
The device should not be used in public facilities,
parks, sports grounds, roads, etc. nor in agriculture
or forestry.
20
Safety information
¾ Only use the leaf vacuum/blower in daylight
or under bright artificial light. Keep your work
area clean and well lit.
¾ Only use the leaf vacuum/blower in dry weath-
er conditions. Keep it away from rain or damp.
The ingress of water into the leaf vacuum/blower
increases the risk of an electric shock.
¾ Do not touch any dangerous moving parts be-
fore the moving parts have come to a stand-
still and the power pack has been removed.
¾ Even if all safety and operating instructions
are heeded, there is always a residual risk of
injury and property damage. Always bear this
in mind.
¾ Do not use the device if it is raining or there is
a risk of storms.
¾ Replace all worn or damaged information
signs on the device.
¾ Only use power packs and chargers approved
by the manufacturer. The designations of the
approved power packs/chargers are listed in
the enclosed CE Declaration of Conformity.
Position
The identification plate is located on the device
casing.
Note
The label has the status of a certificate. It
must never be altered or obliterated.

Identification plate

Safety information