Model And Serial Number Location; Cabinet Installation - Frigidaire FEB24S2AB Instrucciones De Instalación

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
see Figure 5. If your appliance is to be connected
to a 3 wire grounded junction box (US only),
where local code permit connecting the appliance-
grounding conductor to the neutral (white) see
Figure 4.
NOTE TO ELECTRICIAN: The armored cable leads
supplied with the appliance are UL-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than temperature rating of household wiring. The
current carrying capacity of the conductor is governed by
the temperature rating of the insulation around the wire,
rather than the wire gauge alone.
Where local codes permit connecting the appliance-
grounding conductor to the neutral (white) wire
(US Only) (see figure 4):
1. Disconnect the power supply.
2. In the junction box:
connect appliance and power supply cable wires as
shown in Figure 4.
Cable from Power Supply
White
Wire
(Neutral)
Red
Wires
Ground Wire
(Bare or Green Wire)
Cable from appliance
Figure 4
3-WIRE GROUNDED JUNCTION BOX
If oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle,
or where local codes DO NOT permit grounding
through the neutral (white) wire, the appliance
frame MUST NOT be connected to the neutral wire
of the 4-wire electrical system (see figure 5):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the junction box:
connect appliance and power supply cable wires as
shown in Figure 5.
All manuals and user guides at all-guides.com
Black
Wires
Junction
Box
White Wire
(Neutral)
U.L.-Listed Conduit
Connector (or CSA listed)
Cable from Power Supply
Ground
Wire
Red
Wires
Ground Wire
(Bare or
Green Wire)
Junction
Box
Cable from appliance
4-WIRE GROUNDED JUNCTION BOX

Model and Serial Number Location

The serial plate is located along the side of the oven door
in the open position.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your oven.
Serial Plate
Location

5. Cabinet Installation

Insert appliance into cutout. Use the screws provided to
fasten the front frame of the appliance to the cabinet.
The mounting holes in the front frame of appliance may
be used as a template to locate the appliance mounting
screw holes.
To fasten the appliance to the cabinet:
1. Line up the 2 mounting holes on the decorative trim
(ventilation) (taped to the oven side panel) with the
lower mounting holes on each side of the oven frame,
below the oven door (see figure 6).
2. Use 2 screws from the miscellaneous parts bag to
secure the decorative trim (ventilation) and appliance
to the cabinetry.
4
White Wire
Black
Wires
White Wire
U.L.-Listed Conduit
Connector (or CSA
listed)
Figure 5