Technisch manual
IPC MicroTimer
Introduction:
The MicroTimer is a complete electronic timer with two outputs which can be used to select general
functions for a set time, with a prior time setting and a post time setting.
Functions:
Two control channels with fixed relays output
•
Prior time setting 0-255 minutes
•
Main setting 0-255 minutes
•
Post time setting 0-255 minutes
•
Service hours' counter (cannot be reset)
•
Service counter can be reset
•
Power supply both for 24 volt as 230 volt
•
Specifications:
Very strong plastic housing
•
Suitable for internal or external installation
•
Three keys: Start / Pause, Timer & Stop (internal and external)
•
Bright green 2-digit LED display
•
Versions:
The MicroTimer is available in two different types, the difference between the two of them lies mainly in
the applied software:
Software –S:
Three keys on the front
Rapid start function via Start / Pause key
Main time shortened with Stop key
-S, signal output
Software –P:
Three keys on the front
Rapid start function via Start / Pause key
Main time shortened with Stop key
-P, pulse output
Software description:
(The software version is shown on the front plate of the MicroTimer, under the housing cover plates.)
- S software version
The timer can be started by pressing the Timer key. Before starting the main time, a prior time can be
selected, which is run before the main time. You can interrupt the main time by pressing the Start /
Pause key. If the Stop key is depressed, either the timer will stop operating or the post time will follow
automatically (depending on what has been previously set).
- P software version
This version is the same as the –S version, except for the control diagram. (See "Control Diagram").
Technisch manual
IPC MicroTimer
Ontwikkelingsspecificaties, wijzigingen voorbehouden
IPC Systems B.V.
Pagina
10
Versie
1.3
Datum
14-03-'02
1