Uline Н-2561 Instrucciones De Ensamblaje página 2

Figure 2
Figure 3
Figure 4
Figure 5
PAGE 2 OF 6
ASSEMBLY CONTINUED
3. Place one table slat on each side of the plastic
base (seat area). Pre-drill the end holes on the slats
using the power drill and 3/8" drill bit. Loosely attach
slats to the plastic base using 4" lag screws, power
drill and 3/4" socket bit (will tighten later in step 8).
(See Figure 2)
4. Pre-drill center holes on the slats using the power drill
and 3/8" drill bit. Loosely attach slats to plastic bases
using the 4" lag screws, power drill and 3/4" socket
bit (will tighten later in step 8). ( See Figure 3)
5. Determine the spacing for the slats on the tabletop.
Pre-drill holes on the slats using the power drill and
3/8" socket bit. Loosely attach slats to the plastic
base using 4" lag screws, power drill and 3/4" socket
bit (will tighten later in step 8). (See Figure 4)
6. Turn table upside down.
7. Attach base support board into the indent in the
plastic base bottom using the 3½" lag screws,
washer, power drill and 3/4" socket bit. (See Figure 5)
8. Turn table right side up. Make sure the table is
square and tighten all lag screws.
1-800-295-5510
uline.com
CAUTION! Due to weight of table, seek
assistance to turn table upside down.
NOTE: H-2565 Mounting hardware sold
separately.
0721 IH-2561