Publicidad
Idiomas disponibles
Idiomas disponibles
indicator light will always flash if movement is detected. These are the most
commonly used settings.
1. If both switches are set to the ON position as shown in picture 1, the
LED will flash each time a movement is detected. After each signal, a 5
second waiting time is set as a standard to allow a person to pass
without triggering a signal continuously.
2. If the top switch is set to Off the detector will respect a 5-minute delay
before it will become active again. This is a power saving mode. This
setting can perfectly be used with a loud alarm (which will sound
continuously and loud). A Chime setting on the Alarm unit is not advised
with this delay.
3. If the lower switch is set to Off, the Led light will not flash each time a
signal is detected. This can be convenient for saving battery power.
4. If both switches are in the Off position as shown in Figure 2, the PIR
sensor will respect a 5-minute interval between 2 different signals nor will
the LED window flash.
Low-voltage Reminder Function: The indicator light will be continuously
on when the voltage of the PIR is lower than 2.4V unless its light has been
switched off by setting the internal switches.
Copyright © 2019 Tiiwee. All rights reserved. This manual or any portion thereof may not be reproduced or used in any manner whatsoever.
Publicidad
