Safety Instructions; Commissioning; Assembling The Machine; Preparing For Use With The Planex - Festool SRM 45 E-LHS 225 PLANEX Instrucciones De Servicio Originales/Lista De Piezas De Repuesto

5

Safety instructions

- The machine should only be used by
appointed persons instructed in correct
machine handling.
- Use original Festool accessories only.
- Warning: the machine may contain ha-
zardous dust. Only authorised and qua-
lifi ed personnel with suitable protective
equipment may perform maintenance
work, including emptying the container
and changing the fi lter. Do not operate
the machine without a fully fi tted fi lter
system.
- Observe the safety requirements that ap-
ply for the dust you intend to extract.
- Risk of explosion and fi re hazard: do not
extract sparks or hot dust, fl ammable or
explosive dust (e.g. magnesium, alumini-
um), fl ammable or explosive fl uids (e.g.
petrol, thinner), aggressive fl uids/solids
(e.g. acid, leach, solvent). Operate the
machine in a well-ventilated room!
- Pull the plug from the socket when the
machine is not in use and prior to main-
tenance and cleaning work.
- Check the plug and the cable regularly
and have them replaced by an authorised
after-sales service workshop should either
become damaged.
- Always replace the mains power cable with
the type specifi ed in the manual.
- Do not damage the mains power cable
(e.g. by driving over, dragging, etc.). Do
not pull the plug from socket by the ca-
ble.
- Always use the machine socket for the
purpose specifi ed in the manual.
- Clean the integral water level fl oat regu-
larly and check for damage.
- Do not expose the machine to rain.
- Do not lift or transport the machine by the
handle using a crane or lifting gear.
- For reasons of safety, never operate the
machine from an unearthed socket.
Seen at Ideal Tools.
6

Commissioning

Risk of accident if the machine is ope-
rated using unauthorised voltages or
frequencies.
- The operating voltage specifi ed on the
mobile dust extractor name plate must
match the voltage of the mains power!
- Make sure that the mobile dust extrac-
tor is switched off when plugging in the
mains cable.
6.1

Assembling the machine

The parts included in the scope of delivery
are enclosed inside the dust container [1-1]
on delivery and must be removed before
initial use.
• Affi x the accompanying sticker in your
national language over the text fi eld on
the warning sign [1-3].
Inserting the fi lter bag/disposal bag
• Remove the top section [Fig. 2].
• Insert the disposal bag [Fig. 3] or the fi lter
bag [Fig. 4].
• Replace the top section and close the lo-
cking clips.
Inserting the cable hook
• Slide the cable hook [1-7] for storing the
mains power cable into the holder [1-8]
from above.
6.2 Preparing for use with the
PLANEX
To use the mobile dust extractor in combi-
nation with the PLANEX:
• Fit the tool holder as per the enclosed
installation instructions.
• You can store sandpaper, the brush seg-
ment and the PLANEX on the tool holder
storage area.
• Only use disposal bags when performing
extraction work with the PLANEX.
6.3

Switching the machine on/off

Make sure that the connected machine is
switched off before actuating the switch
[1-4].
"0" switch position
Appliance socket [1-5] is disconnected from
the power, mobile dust extractor is switched
off.
11
WARNING