Charging The Battery Pack - Toro Flex-Force Power System 41cm 60V MAX Manual De Instrucciones

Charging the Battery Pack

Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Ensure that the vents on the battery and charger
are clear of any dust and debris.
Figure 25
1. Battery pack cavity
2. Battery pack venting areas 6. Handle
3. Battery pack terminals
4. Battery-charge-indicator
button
2. Line up the charger with the cavity on the back
of the battery pack
3. Slide the charger into the battery pack until it is
fully seated (Figure
4. To remove the charger, slide the charger
backward out of the battery.
5. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator Indicates
light
Off No battery pack inserted
Green Battery pack is charging
blinking
Battery pack is charged
Green
10).
5. LED indicators (current
charge)
7. Charger
(Figure 25).
25).
Red Battery pack and/or battery charger is over or under
the appropriate temperature range
Red Battery pack charging fault*
blinking
*Refer to Troubleshooting (page 25)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page
g330066
18
for more
24).