IRIS Touch 200 Range Dialler Manual De Instalación Rápida página 6

UK
3. Configuring the IRIS Touch Dialler
The majority of configurations can be carried out via the touch screen interface
display on the IRIS dialler. For more complex systems, for example where the data
port is used, additional configuration is available via the USB connector using a
laptop / PC and IRIS dialler configuration software (available via the Chiron website
at www.chironsc.com).
The touch screen display on the IRIS dialler provides an Installation Wizard which
guides you through a set of instructions for configuring the dialler. It is
recommended that you use this Wizard as it automatically carries out tests as you
proceed through the configuration.
Note: To select an option on the screen, touch the screen display.
Use the following procedure to configure the IRIS Touch Dialler:
1. Plug the power cable into the battery backed supply of the alarm panel. The
cable with the white stripe is the –ve connection. Ensure that the display on the
dialler becomes active.
The dialler carries out a self test and the Welcome screen then displays.
Note: If the power has been connected for the first time the Language menu
displays. Select the appropriate language from the list of languages available.
2. Select the Installer Menu option from the Welcome screen.
Note: The default installer password is 111111.
3. Select the Installation Wizard option from the Installation Menu.
4. Follow the remaining instructions on the screen to complete the configuration.
Note: During the installation procedure the Wizard shows the GSM/GPRS
signal strength. At this time the antenna position can be adjusted for optimum
signal. (GSM / Ethernet & GPRS only).
Once the installation is completed successfully the message Status - System
OK is displayed on the Welcome screen and the LED Indicator on the top of the
unit is on steady.
Note: If the 'Alarm Override' mode is selected, the IRIS Touch Dialler replaces
the phone number and the account number used by the alarm dialler with the
IP address of the Monitoring Centre and Account Number entered during
configuration, so there is no need to change any settings on the alarm dialler. If
this is not appropriate (e.g. if the alarm dialler uses more than one account
number) then the telephone number dialed by the alarm dialler should be set to
the IP address of the Monitoring Centre in 12 digit format (e.g. 192.168.0.34
becomes 192168000034).
5. Carry out all the standard alarm signaling tests appropriate for the alarm
system.
6. Push up the slider to cover the touch screen.
The installation is complete.
2 IRIS Touch 200 Range Dialler Quick Installation Manual (Version 1.0)
All manuals and user guides at all-guides.com