Bosch Professional GLM 30 Manual Original página 11

All manuals and user guides at all-guides.com
OBJ_BUCH-2099-004.book Page 11 Thursday, April 21, 2016 1:10 PM
 Do not point the laser beam at persons or animals and do not look into the la-
ser beam yourself, not even from a large distance.
Note: The measured value typically appears within 0.5 seconds and no later than
4 seconds. The duration of the measurement depends on the distance, the lighting
conditions and the reflective properties of the target surface. Upon completion of the
measurement the laser beam is automatically switched off.
Auto-Sum (see figure B)
The auto-sum automatically shows the sum of all individual measurements (e.g. use-
ful for the material calculation).
The auto-sum value is erased as soon as the device is switched off or if it automatically
switches off when no button is pressed after 5 minutes.
The auto-sum is not saved. A subsequent correction of the auto-sum is not possible.
Aim the laser beam at the target surface.
Briefly press the measuring button 2 to initiate the measurement.
The current measured value c appears in the bottom line of the
display. The laser beam is switched off.
To switch on the laser beam, briefly press the measuring button 2.
To initiate another measurement, briefly press the measuring but-
ton 2 again. The current measured value c is displayed in the bot-
tom line. The previous measured value b is displayed in the middle
line. In the top line, the auto-sum a (the sum of the current and
previous measured value) is displayed.
Switching the Sound On and Off (3 601 K72 5..)
Switch the measuring tool off.
Press and hold the measuring button 2. When the cur-
sor is on the desired setting, release the measuring
button 2. After releasing, the measuring tool switches
itself on with the selected setting.
Changing the Unit of Measure (3 601 K72 57.)
Switch the measuring tool off.
Bosch Power Tools
English | 11
1 609 92A 297 | (21.4.16)