Hardware Installation - Vivotek SUPREME SD9363 Guía De Instalación Rápida

3

Hardware Installation

1. Jot down the camera's MAC address for later reference.
2. The camera weighs 6kg. Select a rigid mounting location to prevent vibration to the
camera. Attach the alignment sticker to the wall.
3. Drill 4 pilot holes (9.5mm in diameter and 4cm deep) into the wall, and then hammer
in threaded anchors. Note that you should hammer the anchors with hex nuts on
them so that the threaded poles will not be deformed! If preferred, drill another hole
for routing cables.
SDXXXX
0002D10766AD
4. Remove the hex nuts, washers, and leave one washer on each of the threaded poles.
All manuals and user guides at all-guides.com
EN-3
Ø 9.5mm or 3/8"