After Using The Machine; Machine Long Inactivity; First Period Of Use; Maintenance - Viper AS4335C Instrucciones De Uso

INSTRUCTION FOR USE
Recovery water tank emptying
1. Stop the machine.
2. Lift the brush/pad-holder deck (I, Figure 7) and the squeegee
(H) by pressing the pedal (G).
3. Push the machine to the appointed disposal area.
4. Empty the recovery water tank with the hose (F, Figure 7).
Then, rinse the recovery tank (C, Figure 9) with clean water.
5. Remove the recovery tank lid (A, Figure 9) and clean the
inside of the cover and the filter floater grid (B) with clean
water.
6. Check the recovery tank (D, Figure 9) whether there is
foreign body jam and clean it.
CAUTION!
When draining the wastewater, the vacuum tube for waste must be folded (C, Figure 10) and lowered to a lower
position (D, Figure 10), and then open the lid of the vacuum tube for waste to drain the water. Do not make
the outlet of the vacuum tube for waste face upward to drain the water vertically. This is to avoid wastewater
spilling onto the operator.
7. Perform steps 1 to 4.
Solution/clean water tank emptying
8. Empty the solution tank with the outlet cover (E, Figure 10). After working, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the brushes/pad-holders.
2. Empty the tanks (A and B, Figure 10) as shown in the previous paragraph.
3. Perform the daily maintenance procedures (see the Maintenance chapter).
4. Store the machine in a clean and dry place, with the brushes/ pad-holders and the squeegee lifted or removed.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the machine paragraph.
2. Disconnect the main power.

FIRST PERIOD OF USE

After the first 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible
parts for wear and leakage.

MAINTENANCE

WARNING!
Maintenance procedures must be performed after the machine is turned off and the cable is disconnected. In addition,
carefully read the safety chapters in the manual.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel or an authorized Service Center. This
manual only describes the general and common maintenance procedures.
A
B
Figure 10
Figure 10
15
ENGLISH
C
D
E