Cleaning And Storage - JOCCA 8530 Manual De Instrucciones

12-E
replace it correctly for you.
-Do not immerse the appliance or any part of it in water or any other
liquid.
-Do not pull the cable to unplug the appliance from the mains, always
pull from the adapter.
-If your appliance has been dropped or fallen into water or any other
liquid do not use it or try to repair it. Take it to the JOCCA technical
service.
-Do not use the appliance with wet hands or feet or barefoot.
-Do not place the appliance on a hot surface.
-Excess pressure can cause damage, do not go over the maximum
pressure indicated for the object you are going to inflate.
-To avoid damage to the appliance and overheating, make pauses
after every 10 minutes continuous operation of the compressor. If it
has overheated, switch the appliance off for 30 minutes.
INSTRUCTIONS FOR USE
-Switch the ignition of your car on so that the compressor has 12V
power supply.
-Insert the adaptor into the car lighter.Before inflating any object, con-
sult the appropriate pressure for the object.
-Select the necessary nozzle or adaptor and screw it into the connec-
tor with the flange in raised position. Once your have inserted the
nozzle, secure it by lowering the flange. (DRAWING 1).
-It is now ready to inflate any object.
-Once you have finished the inflation process, unplug the appliance.
MOST FREQUENT PROBLEMS
-The compressor works but does not inflate:
-Make sure that the adaptors are correctly connected and that the
valve is fitted correctly before lowering the connector.
-If the wheel is totally deflated, the valve may be obstructed, in this
case, raise the vehicle with the jack, thus re-establishing the air cham-
ber.
-The compressor works slowly:
-Leave it to cool for 30 minutes if it has overheated.

CLEANING AND STORAGE

-Do not use abrasive detergents or products that may damage the
appliance.
-NEVER IMMERSE THE APPLIANCE IN WATER OR ANY OTHER
LIQUID.
-Always use a damp cloth or sponge to clean the exterior of the
appliance.
TECHNICAL SPECIFICATIONS
DC 12V
300 PSI.
This device conforms to the safety requirement and provisions of
Directive 2004/108/EC on Electromagnetic Compatibility.
PROTECTION OF THE ENVIROMENT – DIRECTIVE
2002/96/EC
This product has been designed and manufactured with high quality
materials and components that can be recycled and reused.
When you see the symbol of a crossed out litter bin on whe-
els next to a product, this means that the product conforms to
the European Directive 2002/96/EC.
Please obtain information about the local recycling system for
electric and electronic products.
Follow the local rules and do not dispose of used products by thro-
wing them in the normal bins at home. Proper recycling of your used
product will help avoid negative impacts on the environment and peo-
ple's health.
E-13