Broan Elite RM53000 Serie Manual Del Usuario página 8

INSTALL THE DUCTWORK
(DUCTED HOODS ONLY)
!
CAUTION: To reduce the risk of fire, use
only metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions will
reduce the performance of the hood. Use as
few of them as possible. Larger ducting may
be required for best performance with longer
duct runs.
4. Install a roof or wall cap. Connect round metal
ductwork to cap and work back towards hood
location. Use duct tape to seal the joints
between ductwork sections.
INSTALL ELECTRICAL
WARNING: Electrical wiring must be
done by a qualified person(s) in
accordance with all applicable codes and
standards. This range hood must be
properly grounded. Turn off electrical
power at service entrance before wiring.
1. Plan where the hood will be located above the
cook top. Refer to the "INSTALL MOUNTING
BRACKET" section for hood mounting height
options.
2. Install a standard 2" x 4" wall outlet box and
3-blade 125 volt, 15Amp grounded receptacle.
3. Mount the receptacle 18" to 22" above the
bottom of the hood.
4. Locate the receptacle within boundary shown
and off center of the ductwork (to allow for
power cord plug and flue clearance).
ROOF CAP
DECORATIVE
FLUE
HOOD
24" TO 30" ABOVE
COOKING SURFACE
(See "INSTALL MOUNTING
BRACKET" section for
mounting restrictions)
CENTER LINE
OF HOOD AND
DUCT
- 8 -
6"
ROUND DUCT
WALL
CAP
ROUND
ELBOW
6"
ADAPTER