White Balance - NEO PROTON IP QW ZOOM Manual De Usuario

Dimmer curve Settings
• To enter dimmer mode and choose to simulate different
dimming curves, press the MENU button repeatedly until
the display shows Dimmer Mode, then press ENTER.
• Press the button MENU repeatedly until Dimmer Mode
shows, and press ENTER button to accept.
• Use the button UP/DOWN to select a dimmer curve .
• Press ENTER button to con rm.
Back light
• To activate backlight display press the button MENU so
many times until shows Back Light, and press ENTER
• Press the button UP/DOWN to select On - 10S - 20S - 30S.
Fixture information
Press the MENU button so many times until shows Infor-
mation, and then press ENTER button. 2. Use UP/DOWN
button to select: Fixture Hours - Version - UID .
- Fixture Hours
This option shows the user the amount of hours
the PROTON IP QW ZOOMhas been in use
throughout its lifetime. Select Fixture Hours.
- Version
This option shows the user the software version
currently installed in the unit. Select Version.
Led frequency
• To adjust the frequency of the LEDs, press the MENU but-
ton repeatedly until the display shows LED Frequency, and
then press the ENTER button.
P. 16
PROTON IP QW ZOOM
ENGLISH VERSION
All manuals and user guides at all-guides.com
• Select the frequency 600 Hz - 25 KHz using the UP/
DOWN buttons,then confirm with ENTER.
Key lock
• The password to unlock access to menu changes is this key
sequence: UP + DOWN + UP + DOWN (followed by ENTER).
Fan mode
To set the rotation speed of the fans refer to the following guide:
• Press the MENU key repeatedly until the display shows
Fan Mode, then press the button ENTER.
• Select by pressing UP/DOWN one of the following op-
tions: Auto - High. It is possible choose the speed of
rotation of the fans from: fast High and automatic Auto.
• Press the MENU button to go back or wait a few seconds
to exit the setup menu.

White balance

Enter the White balance to adjust the Red, Green, Blue and
White values to set the white balance. • Press the button
MENU so many times until shows White Balance
• Select the color R, G, B, W through the buttons UP/
DOWN, then press the button ENTER.
• Using UP/DOWN button, select the desired color value 125-255.
• Press ENTER button to continue to the next color R, G, B, W.
• Continue until the desired mix is obtained.
• Press the MENU button to go back to the main menu.