Baby Mode - Burigotto BAHIA Instrucciones De Uso

There are four recline angles
"1-4" for toddler mode Angle
indication: with top and
bottom triangles aligned
(9-18KG).
There is one recline angle for 1
junior mode, it is marked as "1"
red triangle (15-36KG).
Make sure that vehicle seat
belt will be tight when
adjusted in reclining position
and vice versa if seat was
already buckled up properly
previously.
Height Adjustment for Head Support and
Shoulder Harnesses
Please adjust the head support and shoulder harnesses to proper height
according to the child's height.
• When used in baby mode,the shoulder harness height must be even
with child's shoulders.
• When used in toddler mode, the shoulder harness height must be even
with child's shoulders.
• When used in junior mode, the shoulder belt guides must be even with
child's shoulders.
If the shoulder harnesses are not at proper height, the child may be thrown
from the child restraint when there is an accident.
Squeeze the head support adjustment
lever, meanwhile pull up or push down
the head support until it snaps into one
of the 11 positions.
The head support positions are shown
as

Baby mode

(Rearward Facing Mode/for Child under 18kg)
• Please install the child restraint on the rear vehicle seat and then put the
child in the child restraint.
Installation for Baby Mode
• Please adjust the child restraint to proper angle (3 positions for
babymode). Angle indication: With top triangle and blue triangle
aligned.
• Make sure the shoulder harness is adjusted to proper height before
installing this child restraint.
• When installing and adjusting the safety belts, make sure that both the
shoulder belt and the waist belt are not twisted and will not stop the
safety belts from functioning properly.
22
1