How To Use - Electrolux EQB20C2MMS Manual De Instrucciones

23 electrolux how to use

How to use

Activate heating and cooling
This unit will not dispense hot or
cold water until the switchers are
activated.
To activate, push top side of power
switches in to start heating and
cooling water.
- If you do not want to heat water,
push bottom side of red switch in.
- If you do not want to cool water,
push bottom side of green switch
in;
Activate nightlight
Push top side of blue power switch
to turn light on. Push bottom side in
to turn light off.
Dispensing water
This unit has been tested and
sanitized prior to packing and
shipping. During transit dust and
odors can accumulate in the tank
and lines. Dispense and dispose at
least one quart of water to prior to
drinking any water.
All manuals and user guides at all-guides.com
Sometimes when water is dispensed
for more than 2 minutes, the pump
fails to take the necessary amount of
water, and gets block, in this case
the lack of water indicator light on
control panel will turn on. If this
happens, just open the cabinet door,
then close it, and wait for 2 minutes,
then the dispenser will return to
dispense water.
When the bottle is empty, replace it
with a new bottle. (see instructions
of how on page 25).
Dispensing cold water
After setup, it will take up to 1 hour to
get water to maximum cold
temperature. During this time the
compressor could run continuously.
This is normal.
1. Position bottle, glass, pitcher or
cooking pot below spout.
2. Depress cold water control
downward to start cold water flow.
3. Release control once desired fill
level is achieved.
Dispensing normal water
1. Position bottle, glass, pitcher or
cooking pot below spout.
2. Depress normal water control
downward to start normal water
flow.
3. Release control once desired fill
level is achieved.
Dispensing hot water
After setup, hot water will be available
in 15-20 minutes.
1. Position bottle, glass, pitcher or
cooking pot below spout.
2. Slide red button away from you and
depress hot water control
downward to start hot water flow.
3. Release control once desired fill
level is achieved.
how to use electrolux 24