THERMEx MANCHESTER SMART Manual De Instrucciones página 38

38 THERMEX MANcHESTER SMART
4
Mount the cover panel onto the top of the
hood.
INSTALLATION USING KEYHOLE BRAcKETS
Once the hood has been set for the correct type of exhaust, the hood must be fitted. This can be carried out by mounting the hood on the
keyholes on the back of the hood. Using the key holes to mount the hood means that it is not necessary to install the hood under a cupboard.
This is type of installation is carried out in the following steps:
1
Measure out and mark the position of the
two keyholes.
4
NOTE: The screws must not be screwed in
further than the hood can be installed.
All manuals and user guides at all-guides.com
2
Drill the holes into the wall using a suitable
drill for the type of wall.
5
Hang the hood on the screws.
M 520232061204092018
3
x2
x2
Ensure that the rawlplugs and screws are
suitable for the wall material in question and
insert them into the pre-drilled holes.
6
Remove the filters from the hood.