Stanley FL5W10 Manual Del Usuario página 3

specific safety instructions for
spotlights
• Allow the spotlight to fully cool down before storage.
• Keep combustible materials away from spotlight lens. Extreme heat can cause fires.
• Never place the light face-down on any surface when it is switched on or cooling.
• Do not leave the spotlight unattended. Keep children and animals away from the work
area.
• Inspect the lens for damage following impact or if the spotlight is dropped. Do not operate
without the lens in place or with a damaged lens.
• Never look directly into the light or shine the light into another person's eyes.
Instructions pertaining to waterproof spotlights
The rubber O-ring acts to preserve the waterproof qualities of the spotlight. The O-ring
contacts the end cap to prevent water from entering the gap. An undamaged rubber
O-ring, rubber ring guard and lens, and proper sealing of the end cap before use are very
important.
cAutION: to reduce the risk of property damage:
• Attempting to remove the rubber O-ring; use of the unit with a damaged O-ring, rubber
ring guard or lens; improper sealing of the waterproof end cap; and/or submerging this
unit in depths greater than 1.8 meters may cause the unit to no longer be waterproof.
Do not submerge the unit if these conditions exist or the unit could sustain permanent
damage.
• Submerging this unit in depths greater than 1.8 meters and/or operating it in water
temperature other than between 5ºC and 40ºC could result in leakage, warping or
malfunction, causing permanent damage to the spotlight.
features
1. Rubber O-ring
2. Translucent waterproof end cap
3. Charging socket (for use with mains AC charger and DC charger)
4. Battery/charge status LED indicator
5. Rubber ring guard
6. 5 watt LED bulb
7. Dimmer selector knob
8. On/off power knob
9. Pistol grip
10. Mains AC charger
ENGLISH
FL5W10EU_Manual_040612.indd 4-5
4
11. DC charger (optional accessory)
12. End cap detail
13. Dot icon (for alignment to the triangular icon on the end cap)
14. Triangular arrow icon (for alignment to the dot icon on the rear of unit)
readInG tHe Battery/cHarGe status led
IndIcator
The battery and charging status LED indicator is located directly above the charging
socket under the waterproof end cap on the back of the unit. It lights or flashes in three
colours to indicate the following:
When charging:
Green & Red (flashing alternately): Battery is overheated due to extensive use or
recharging. The charging process will stop at this stage and will automatically resume after
a cool down period of several minutes.
Green:
Battery is in a fully charged state.
Orange: Battery is in a partially charged state.
Red: Battery needs to be recharged.
When operating:
Green: Battery is operating at full voltage.
Orange:
Battery is operating at partial voltage.
Red: Battery is operating at low voltage, and should be recharged.
Red (flashing): Battery is operating at extremely low voltage. The built-in low voltage
protection has activated and the unit will automatically shut down (after sounding several
"beeps"). The unit must be recharged immediately.
When using the dimmer selector:
Green (flashing): The light is adjusting to dimmer setting.
Red (flashing): The light is adjusting to brighter setting.
5 ENGLISHn
4/6/2012 12:05:13 PM