Publicidad
INPUT
FUNCTIONS
INPUT
1
8-16
SPEAKER
OUTPUT
7
1. INPUT CONNECTOR
Connect your guitar to this connector using a
6.3mm TS jack cable.
8-16
2. HIGH/LOW SWITCH
Switch between 1W (low) and 5W (high) power
output using this switch.
SPEAKER
OUTPUT
3. TONE CONTROL
Adjust the tone of your amplifier using this dial.
Fully anticlockwise will produce a thinner sound,
fully clockwise will produce a broader sound.
4. VOLUME CONTROL
Adjust this dial to control the overall output sound
from the amplifier. This dial will also affect the
volume sent to the speaker output connector on
the rear of the amplifier.
5. STANDBY LIGHT
This light will illuminate when the amplifier is
switched on.
6. POWER SWITCH
This switch turns the amplifier on and off. When
the amplifier is switched on, allow a moment for
the tubes to warm up before playing. This will
increase the lifespan of the tubes and create a
better output sound.
5W
1W
TONE
5W
1W
TONE
2
3
3
STANDBY
VOLUME
STANDBY
VOLUME
4
5
INPUT POWER: 220-240VAC, 50-60Hz
MADE IN
POWER CONSUMPTION: 50W
CHINA
SERIAL NO.:
7. SPEAKER OUT CONNECTOR
Connect an external speaker to this connector
using a 6.3 TS speaker jack cable.
8. MAINS POWER CONNECTOR
Connect the amplifier to the mains power using
this connector. Only use the mains cable provided
INPUT POWER: 220-240VAC, 50-60Hz
MADE IN
POWER CONSUMPTION: 50W
CHINA
with the product.
SERIAL NO.:
NOTE: This connection outputs at an amplifier level.
It is recommended to use a speaker jack cable
capable of carrying the required load.
5V
6
8
Publicidad
