Introduction; Device Description; Scope Of Delivery - Scheppach GS50 Instrucciones Originales

1. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer
we wish you a pleasant and successful working expe-
rience with your new machine.
Note:
According to the applicable product liability law the
manufacturer of this device is not liable for damages
which arise on or in connection with this device in
case of:
• improper handling,
• non-compliance with the instructions for use,
• repairs by third party, non authorized skilled work-
ers,
• installation and replacement of non-original spare
parts,
• improper use,
• failures of the electrical system due to the non-
compliance with the electrical specifications and
the VDE 0100, DIN 57113 / VDE 0113 regulations
Recommendations:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord-
ance with the recommendations.
The operating instructions contain important informa-
tion on how to operate the machine safely, profes-
sionally and economically, how to avoid danger, cost-
ly repairs, reduce downtimes and how to increase
reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information.
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
In addition to the safety notes contained in the pre-
sent operating instructions and the special regula-
tions of your country, the generally recognized techni-
cal rules for the operation of woodworking machines
must be observed.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
2. Device Description (Fig. 1 - 2)
1. Loading slot
2. Mains power connection
3. Locking mechanism
4. Adjusting screw
5. Frame
6. Drip tray
7. Support feet
8. Idler
9. On/off switch
10. Switch for direction of roll rotation
11. Reset switch
12. Upper section of machine
A. Wheel cap (2x)
B. Washer (4x)
C. Cotter pin (2x)
D. Fillister-head Phillips screw M5 x 45mm (2x)
E. Fillister-head Phillips screw M5 x 20mm (6x)
F. Pin Ø8 x 70mm (2x)
G. Stopper

3. Scope of delivery

• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
GB | 19