Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. IMPORTANT INFORMATION
3.1 Important Information
●
In order to get the full screen brightness and easy visability of all numbers and symbols,
we recommend you use the included mains adaptor rather than batteries for the main
unit.
●
The remote sensor will work better if the main unit is powered by the included mains
adaptor rather than batteries.
●
Regarding the wireless remote sensor (which can be positioned indoors or outdoors), if
it is used outside particulatly in cold conditions we recommend the use of Lithium AAA
(requires 2) batteries as this will result in a more powerful signal and ensure no signal
loss. This is only precautionary advice and the remote sensor does work fine with normal
Alkaline batteries.
●
The weather station needs to be powered for 12 hours before an accurate predition will
display.
3.2 Initial Operation
●
Open the Weather Station Battery compartment.
Insert 2 x AA batteries observing the correct polarity (+ and - marks) or connect the
●
mains power. Close the battery compartment.
●
When the power is connected all the icons on the LCD display will light up for 3 seconds,
you will hear a beep tone and the weather station will start to detect the indoor
temperature and humidity.
●
Next the Weather Station will attempt to connect with the outdoor sensor. This lasts
approximately 3 minutes and is displayed by the RF icon
●
Remove the battery compartment on the Wireless Outdoor Sensor, insert 2 x
AAA batteries observing the correct polarity (+ and - marks) and close the battery
compartment.
●
Once the weather station has created a connetion to the outdoor sensor the clock will
start automatically searching for the WWVB Signal to set the time and date.
If Weather Station failed to receive transmission from the outdoor sensor ("- -" is
●
displayed on the LCD), press and hold ▼ button for 3 seconds to receive transmission
manually. The RF icon
when it is connected.
3.3 Backlight
When using battery power the backlight will be off. Press the SNOOZE/LIGHT button to
●
enable the backlight for 15 seconds.
●
When using Mains power the backlight will be lit continuously. To change the brightness
of the backlight switch the backlight switch to eiher HI or LO.
All manuals and user guides at all-guides.com
will flash on the LCD and the outdoor temperature will show
flashing.
5
Publicidad
Capítulos
Tabla de contenido
