7. Evaporator inlet
9. Front room temperature display
11. Connector of air exhaust duct
CONTROL PANEL (picture C)
A. Power button ON/OFF
C. Mode button
E. Timer / Temperature down button
G. High speed lamp
J. Automatic mode
lamp
L. Dry mode
lamp
N. Timer button
P. Top room temperature display
REMOTE CONTROLLER – picture D
The remote controller transmits signals to the system.
Button "A" - the appliance will be started when it is energized or will be stopped when it is in operation, if you press this button.
Button "C" - press it to select operation mode: "J", "K", "L" or "M".
Button "B" - press it to select fan speed in sequence.
Button "D" / "E" - press to adjust the room temperature and the timer.
Button "I" - press to set or cancel sleep mode. Child lock function is not available via remote control.
Button "N" - press to set the time of automatic off and automatic on.
Button "O" - press to set or cancel louvers swing mode.
OPERATION OF THE CONTROL PANEL
AUTOMATIC / COOL / DRY / FAN
1. Turn on the device.
a) Connect the device.
b) Press the "A" button, then the device beeps once and turn on.
c) LED
displays (9 and P) shown the room
2.Choose the operating mode
Press the "C" button to select the desired mode of operation by sequence:
Automatic mode "J" -> Cooling mode "K" -> Drying mode "L" -> Fan mode "M"
3. Adjust temperature
The temperature can be set within a range 15°-31°C. Press "D" or "E" button to increase or decrease the temperature by 1°C by
pressing once. The device LED panel shows the target temperature for 5 seconds and then displays the room temperature.
4. Adjust fan speed
Press the button "B" to select a desired fan speed shows by sequence:
Low speed "F" -> High speed G
5. Power
When you press the "A" button again, the device will sound "di" and stop working.
6. Press this button "I" to enter the sleep mode of device or keep the button for few seconds to switch on child lock function.
7. Press this button "N" to set a timed shutdown.
8. Press this button "O" to set air swing oscillation in left and right directions.
Each mode working principle:
AUTO "J" mode:
Once the "J"
mode
operation is selected, the indoor temperature sensor operates automatically and it selects one of below operation
modes:
* When the room temperature ≥24°C the unit will automatically select cool mode "K" mode.
or
*When the room temperature
Once, the auto mode "J" operation is selected, the indoor temperature sensor operates automatically, it selects operation mode
between fan "M" mode or "K" cool mode to keep desired room temperature.
temperature and starts working in automatic mode.
< °C, the unit will automatically select high fan speed mode "M..".
24
8. Drain plug
10. Air exhaust duct
12. Window exhaust adapter
B. Fan speed button
D. Timer / Temperature up button
F. Low speed lamp
I. Sleep mode / Child lock button
K. Cool mode
lamp
M. Fan mode
lamp
O. Oscillation button
R. Power lamp
6