Uline H-5048 Manual De Instrucciones página 4

1. Unlatch the three clamps on the top of the unit
and remove cap. Remove micro cloth filter and
Intercept® Micro Filter. (See Figure 3)
Figure 3
2. Check to make sure the dome filter did not shift
during shipping. (See Figure 4)
Figure 4
3. Replace the Intercept® Micro Filter and the micro
cloth filter into the vacuum. Replace the cap and
relatch the three clamps.
4. Push the hose into the cap opening. (See Figure 5)
Figure 5
WAND ASSEMBLY
1. Fasten the ends of the wands together. Pull back to
open purple latch on lower half of wand. Align notch
on inside of lower half with groove on outside of upper
half and insert together. To tighten into position, close
the purple latch when wand is at desired height.
(See Figure 6)
Figure 6
PAGE 4 OF 24
Latch
ASSEMBLY
2. Twist the wand into the end of the hose. (See Figure 7)
3. Attach the floor tool to end of wand. Align the brass
ring with the groove on the floor tool to ensure a
secure fit. (See Figure 8)
HARNESS HEIGHT ADJUSTMENT
1. Upper harness should sit between shoulder blades for
most comfortable fit. The unit is shipped with the upper
harness in the middle position. Tall users will need to
move the position up. Shorter users will need to move
the position down. (See Figure 9)
2. To move the upper harness, loosen the tensioning
straps. Then, using a #3 Phillips screwdriver, unthread
the screw from the unit. It is located in center of
upper harness. (See Figure 10)
Figure 10
3. The upper harness should be secured by screwing it
all the way in.
Figure 7
Figure 8
Figure 9
Adjustable
Harness
Locations
Upper Harness
Harness Height Adjustments
Tensioning Straps
Pivoting Bar
0919 IH-5048