Safco 1902 Instrucciones De Montaje página 2

3
Slide the E Back
Panel over the
Screw Posts of the
D Left Side Panel
(making sure the
Locking Cams are
facing the edge)
with the Cams
toward the bottom
of the Side Panel.
Secure by turning
each of the en-
gaged cams
clockwise until it
stops.
Repeat with the F
Right Side Panel.
5
Install the B Bottom Panel in the same manner.
B
7
Attach the N Left Shelf Rail and the O Right Shelf
Rail to the underside of the P Shelf, using three I
Small Screws each (the ends WITHOUT rollers should
be flush with the front edge of the Shelf).
O
P
FRONT EDGE
1902-37: 2 of 2; Rev. 2; 1/04
All manuals and user guides at all-guides.com
F D
E
I
ROLLERS
N
Safco Products Company, New Hope, MN 55428
4
Place the A Top
Panel over the Side
Panels so that its
Screw Posts enter
the holes in the tops
of the Side Panels
(making sure the
Locking Cams are
facing the edge).
Secure by turning
each of the en-
gaged cams
clockwise until it
stops.
6
Attach the two K Casters without Brakes to the
Bottom Panel, near the back edge, using four L
Large Screws. Attach the M Casters with Brakes
near the front edge.
8 Install the Sliding Shelf: lift the back rollers on the
Shelf Rails over the front rollers on the Cabinet
Rails, tilt the Shelf enough to start the Shelf
moving, and lower the shelf to push it all the way
into place.
A
M
L
K