Publicidad
Idiomas disponibles
Idiomas disponibles
Installation to Wood Stud Wall
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-
ers are responsible to provide hardware for other types of mounting situations. (not evaluated by UL)
Wall plate (A) must be mounted to a single wood stud. Use a stud fi nder to locate the edges of the stud. Use of an
1
edge-to-edge stud fi nder is highly recommended. Based on the stud's edges, draw a vertical line down the stud's
center. Place wall plate on wall as a template. The top mounting slots must be located 1.48" (38mm) above the
desired display center as shown in fi gure 1.1. Level wall plate, and mark the center of the two mounting holes.
Make sure that the mounting holes are on the stud centerline. Drill two 5/32" (4mm) dia. holes 2" (51mm) deep.
Make sure that the wall plate is level and secure wall plate using two wood screws (C) as shown in fi g. 1.2.
fi g. 1.1
1.48"
(38Mm)
A
CENTER OF DISPLAY
WARNING
STUD
4 of 38
fi g. 1.2
A
C
ISSUED: 09-10-09 SHEET #: 202-9365-4 04-05-11
Publicidad
