essentiel b INCLIN'TV Manual De Instrucciones página 9

installation of wall plate
Begin by positioning the drilling template against the wall using the
spirit level to keep it straight.
Use adhesive or drawing pins to hold the template against the wall
while you drill six holes which will be used to attach the bracket.
The screw fixings supplied with this wall bracket are intended exclusively for fixing to a wall
made up of solid bricks or concrete.
For installation on any other medium, please contact an approved professional installer,
M4x12 ou M5x12
and use the appropriate equipment
M4x12 ou M5x12
60mm
10mm
M4x12 ou M5x12
Insert a concrete rawl plug in each hole. If necessary, you can use a hammer to lightly tap each rawl
plug, so they are at the same level as the wall. Once the rawl plugs are in place, position the wall plate.
Attach the washers and then the lag screws into the rawl plugs which project slightly from the wall, as
indicated in the diagram below.
M6x12 ou M8x16
16 6
V.1.0 V.1.0
installation of wall plate
All manuals and user guides at all-guides.com
M4x30 ou M5x30
Drill the holes with an electric drill and a 10-mm concrete bit.
Remove the template and place to one side.
M6x35 ou M8x40
!
Do not tighten completely until all
•
the screws are in place.
Do not overtighten the screws.
•
This can damage the
needlessly.
Do not release the wall bracket
•
before it is firmly attached to the
wall.
installation of tilting arms
Cover a stable, flat surface with a soft cloth.
•
Place the screen of your appliance on the soft cloth.
•
Locate the threaded mount points on the back of the screen.
•
!
Determine the correct screw length by carefully inserting a match or toothpick and
marking the depth of the mount point. Refer also to the operating instructions for your
screen.
Depending on your screen model and the depth of the mount point, we advise you to use the following
combinations of screw fixings (screws + washers + 1, 2 or 3 spacers):
M4 x 12 metal
M4x12 ou M5x12
M5 x 12 metal
M4x12 ou M5x12
M4/M5 washers
M4x12 ou M5x12
M8-4 spacers
M6x12 ou M8x16
Haut Top
Position Mettre
the knob
wall
la molette
outwards
vers
l'extérieur
Bottom Bas
M4x30 ou M5x30
M4 x 30 metal M6 x 16 metal
screws screws
screws
or
or or
M5 x 30 metal M8 x 16 metal
screws
screws screws
M4/M5 washers No washers
M8-4 spacers
and/or
M8-4 spacers
M8-8 spacers
(if needed) (if needed)
and/or
M8-12 spacers
M6x35 ou M8x40
M6 x 35 metal
screws
or
M8 x 40 metal
screws
No washers
M8-4 spacers
and/or
M8-8 spacers
and/or
M8-12 spacers
Sachets
1~4
5
17 7
V.1.0 V.1.0
installation of tilting arms