Scanning For Dab Stations - Fusion MS-RA60 Guia De Inicio Rapido

• Select MANUAL to select a station
manually.
Select PRESET to select a saved
•
station preset.
3 Select or to tune to the station.
When in MANUAL tuning mode, you can
hold or to quickly advance
through the stations.
Saving a Station as a Preset
1 With an applicable source selected, tune
the stereo to a station.
2 Select > PRESETS.
3 Select SAVE CURRENT.
TIP: You can quickly save the selected
station as a preset by holding

Scanning for DAB Stations

NOTE: Because DAB signals are broadcast
in select countries only, you must set the
tuner region to a location where DAB signals
are broadcast.
1 Select the DAB source.
2 Select
to scan for available DAB
stations.
When scanning is complete, the first
available station in the first ensemble
found begins playing.
Quick Start Manual
NOTE: After the first scan is complete,
you can select
DAB stations. When the re-scan is
complete, the system starts playing the
first station in the ensemble you were
listening to when you started the re-scan.
Connecting to a Garmin
For more information about the watch, see
the watch manual at www.garmin.com
/manuals.
1 Following the instructions in the watch
manual, install the Fusion-Link Lite
from the Connect IQ
watch.
2 On the stereo, select the BT source.
.
3 Select
The stereo remains discoverable for two
minutes.
4 Bring the watch within 3 m (10 ft.) of the
stereo.
NOTE: Stay 10 m (33 ft.) away from
other ANT
5 Open the Fusion-Link Lite app on the
watch.
The first time you open the app on the
watch, the watch automatically pairs with
and connects to the stereo. If you need
to pair to another stereo, in the Fusion-
again to re-scan for
Watch
®
™
store onto the
™
> DISCOVERABLE.
devices while pairing.
®
app
5