Technical Data; Optional Accessories - Marmitek CAT4000 Modo De Empleo

Step 2: Set the CAT4000 to programming mode and set option "Coupler function OFF" (Receive LED 1: OFF). Exit the
programming mode and check whether this solves the problem. Reset the CAT4000 to programming mode and set option
"Coupler function ON" (Receive LED 1: ON). If this does not solve the problem, go to the next step.
Step 3: Check the phase that corresponds to the blinking LED for any component or equipment faults.

TECHNICAL DATA

Rated Voltage
Total power consumption
Signal transmission
Transmission synchronization
Signal sensitivity
Signal/noise ratio
Connection range
Ambient temperature
Relative humidity (non condensing)
Degree of protection
Dimensions

OPTIONAL ACCESSORIES

For programming the CAT4000, you can use the Marmitek PRU256, IRRF7243 or TM13 and EasyControl8. See
www.marmitek.com for more info about these products.
Environmental Information for Customers in the European Union
European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of
with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste
streams. It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by
the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and
human health. For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or
the shop where you purchased the product.
CAT4000
3-phase, 230 VAC +/-10%, 50 Hz
< 2 W
> 5 Vpp in 5 at 120
1 pulse burst at 0°/180°
25 mVpp...6 Vpp at 120 kHz ± 4 kHz
1.35 : 1
2.5 mm2 solid
0 °C Min - 40 °C Max.
30 - 90%
Housing: IP40 according to IEC 60 529
Terminal contact: IP20 according to IEC 60 529
5