General Comments - GALA LAGUNA Manual De Usuario

10
INTRODUCTION
Dear customer,
We congratulate you and thank you for purchasing a Gala whirlpool bath.
Before using the whirlpool bath, please read carefully through the instructions covering each of the
functions in the corresponding sections of this manual. If you require any further explanation, please
contact your Gala distributor.
We are convinced that following these instructions will guarantee your full satisfaction with the GALA
Hydromassage System.

GENERAL COMMENTS

The bathtub's hydromassage system must be provided with sufficient ventilation. For that reason some
provision must have been made for access to, and ventilation of the underside of the bathtub, whether it is
paneled in or bricked in. In the former case, make sure that the clearances between the panels, bathtub
and walls have not been sealed up. In the latter case, it is necessary to fit a door of at least 75x45 cm and a
ventilation grille of at least 200 cm . Access should only be possible with the aid of a tool.
It is important to note that specialist knowledge is required for repairing the mechanisms of this type of
bathtub. Therefore, in the case of detecting any faults please always contact our Customers' Technical
Assistance service and do not try to undertake the repairs yourself.
WATER MASSAGE SYSTEMS
The bathtub can be equipped with two different water massage systems: Side Water Massage and Back
Water massage.
•Bathtubs with Side Water Massage:
The massage is based on water injection through the directional jets on the sides of the bathtub.
•Bathtubs with Side + Back Water hydromassage:
Together with the jets on the side of the bathtub, the water injection can be through four directional jets
located in the back of the bathtub, these providing a gentle massage increasing a great feeling of
wellbeing.
In addition , we have combined with a great feeling headrest, to make your massage more pleasurable.
Manual de usuario
2
User's manual
English