Warranty And Support - Philips L'Or Barista Milk Twister CA6500/90 Manual De Instrucciones

English
8
3 Remove the whisk from the whisk holder (Fig. 9) and rinse the parts under hot running water (Fig.
10).
4 Place the whisk onto the whisk holder. Attach the shaft of the whisk holder to the lid of the milk
frother (Fig. 11).
5 Remove the plug from the wall socket. Clean the outside of the milk frother with a moist cloth (Fig.
12).

Warranty and support

If you need information or support, please visit www.lorbarista.com/support or read the international
warranty leaflet.
Recycling
- This symbol means that this product shall not be disposed of with normal household waste
(2012/19/EU) (Fig. 13).
- Follow your country's rules for the separate collection of electrical and electronic products. Correct
disposal helps prevent negative consequences for the environment and human health.
Troubleshooting
This chapter summarizes the most common problems you could encounter with your machine. If you
are unable to solve the problem with the information below, visit www.lorbarista.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Troubleshooting
Problem
The light in the button flashes but
the appliance does not operate.
The appliance does not froth.
Possible cause
You just prepared hot frothed milk
or hot milk and pressed the button
for milk or hot frothed milk again
without letting the appliance cool
down.
The temperature of the milk is too
high.
You have not placed the lid
properly on the appliance.
You did not attach the frothing coil
to the coil holder.
Solution
If you want to prepare hot
frothed milk or hot milk
again, the milk jug needs to
cool down for a few
minutes before you can use
it again. As long as the milk
jug is still hot, the
temperature limiter makes
sure that the appliance
cannot be operated. You
can rinse the inside of the
milk jug with cold water to
let it cool down faster.
Replace the warm milk with
cold milk or let the
appliance cool down.
Place the lid properly.
Attach the frothing coil to
the coil holder.