Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 28502F
Wrenches: 12mm, 13mm
Drill Bits: None
1
Qty. (4)
M8 x 1.25 x 40mm, CL 10.9
1.
Remove the two plastic fascia rivets from the fascia tabs (do not discard).
2.
Remove the vehicle inboard bolt and the lower bolt located on each side of the end panel.
3.
Raise hitch into position.
4.
Install M8 bolts and conical toothed washers provided.
5.
Re-install the plastic fascia rivets removed in installation Step 1.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2006 Cequent Towing Products
Installation Instructions
Toyota Yaris Sedan
Fascia
Drawbar Kit:
28451
Adapter Kit:
28351
Drawbar must be used in the
RISE position only.
End Panel
Tighten all M8 CL10.9 fasteners with torque wrench to 27 Lb.-Ft (37 N-M).
Do Not Exceed Lower of Towing Vehicle
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Wiring Access Location: PC3, PC4
2
Qty. (4)
Conical Toothed Washer
Sheet 1 of 3
28502N
Part Numbers:
28502
Manufacturer's Rating or
7-26-06
Rev. A
Publicidad
Manuales relacionados para Cequent Towing Products 28502
Resumen de contenidos para Cequent Towing Products 28502
- Página 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 28502N 7-26-06 Rev. A 2006 Cequent Towing Products...
- Página 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 2 de 3 28502N 7-26-06 Rev. A 2006 Cequent Towing Products...
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684 Hoja 3 de 3 28502N 7-26-06 Rev. A 2006 Cequent Towing Products...