Etac Molift Smart 150 Manual De Usuario página 10

Molift Smart 150 / www.etac.com
Safety devices
Molift Smart 150 is equipped with several safety
devices, which are intended to prevent damage to
personnel and equipment in the case of incorrect
use.
The lifter has an overload sensor preventing the
lifter to be operated if the load exceeds SWL.
The lifting arm is hinged to prevent the arm
and suspension from squeezing the user. The
actuator will not produce any force when moving
downwards.
The legs are folded together during transport to
make the lifter as small as possible. When assem-
bling the lifter, the legs must be opened to work-
ing position. The lifting column will not fix into
the bracket if the legs are not adjusted beyond
transport position - a safety feature ensures this.
The electronics are disabled if overheated. Wait
until the lifter has cooled down before using it
again.
Push / Pull handles
Use the pull handles to move the lifter.
Do not push or pull the user,
lifting arm or actuator.
This may cause instability and
lifter may tip over.
The lifter shall only be used for movement
over short distances. It is not a replacement
for wheelchair or similar.
Brakes
Rear castors are equipped with brakes. Step on
pedal to lock brakes. Flip up to unlock.
Emergency Stop / Emergency lowering
Emergency stop
The emergency stop shuts off the power when
pushed in. Turn clockwise to reset (OK to operate
when the green ring is visible).
Electrical emergency lowering
Push and hold button for electrical emergency
lowering to lower lifting arm. The electrical emer-
gency lowering function does not work when the
emergency stop is activated.
Manual emergency lowering
Pull handle on the actuator upwards to start
emergency lowering, and the lifting arm moves
downwards when loaded. The lowering will
increase in speed the higher the handle is pulled.
Release the handle gently. Releasing the handle
too quickly may cause person injury or damage to
the lifter.
The manual emergency lowering function on the
actuator should only be used when the electrical
emergency lowering does not work.
10
Manual
Emergency
lowering
Electrical
Emergency
lowering
Emergency
stop