Main Parts - Kinderkraft UNIMO UP Manual De Instrucciones

•‫ي‬All‫ي‬assembly‫ي‬fittings‫ي‬should always be tightened properly.
•‫ي‬Care‫ي‬should‫ي‬be‫ي‬taken that no screws are loose, because a child could trap parts of
the body or clothing (e.g. strings, necklaces, ribbons for babies' dummies, etc.),
which would pose a risk of strangulation.
•‫ي‬Be‫ي‬aware of the risk of burning cigarettes, open fires and other sources of strong
heat, such as electric bar fires, gas fires, etc. in the near vicinity of the crib
•‫ي‬DO‫ي‬NOT‫ي‬use‫ي‬crib‫ي‬if‫ي‬any‫ي‬parts‫ي‬are‫ي‬missing,‫ي‬damaged,‫ي‬or‫ي‬broken.‫ي‬Contact‫4ي‬Kraft‫ي‬Sp.‫ي‬z‫ي‬
o.o. for replacement parts and instructional literature if needed. DO NOT substitute
parts.
• Only use the mattress sold with this crib, do not add a second mattress on this
one, suffocation hazards.
For chair function: WARNING!
● Used as a chair, the product is designed for children up to 18
kg.
● A chair placed under the window can be used by the child as
a step and cause the child to fall out of the window.‫ي‬

Main parts:

- cradle (A1.1)
- toy bar (A1.2)
- canopy (A1.3)
- mosquito net (A1.4)
- seatbelts (A1.5)
A. Assembly
Install the product on a flat surface. Use the handle for changing the inclination of the backrest
(fig. A2) to adjust the backrest as shown in fig. A3. To be able to change the inclination of the
backrest, move the button to the side (in the direction of the arrow) and hold it, while lifting
the handle up, set the desired inclination angle. Then lock the base until you hear a locking
noise (fig. A4). Again, use the seatback angle handle (fig. A2) to adjust the backrest horizontally
(fig. A5). In order to assemble the roof, slide the plastic catches into the slots on the frame on
both sides until you hear the click of the latch (fig. A6). Then hook the Velcro fasteners and the
rear part of the sunroof around the backrest adjustment lever (fig. A7). Fasten the buckle on
the side of the cot and adjust the straps so that the structure is stiff and stable (fig. A8). The
product is in the cot function position (H1).
B. Positioning
The product has three backrest positions: lying, reclining and sitting positions.
The starting position is the crib (lying) function (fig. H1). In order to adjust the product to the
function of the chair (fig. H5), unfasten the calamari belt on the side of the product. Turn the
product so that the seat is on the floor. Remember that the floor is clean and dry. Remove the
stiffening board through the Velcro opening on the back of the backrest (fig. B0). NOTE! The
23