SecuCare PR30330 Manual De Montaje página 11

5
The Threshold Ramp can be attached to a slippery surface (e.g. laminate or slippery tiles) using the
supplied flat laminate feet. Attach the supplied double-sided tape stickers to the laminate feet.
6
Thoroughly clean / degrease the surface!
Attach the laminate feet (place them evenly over
the width of the doorstep, at each end and in the
middle) and remove the release liner from the
double-sided tape.
7
Now place the SecuCare Threshold Ramp in the right location and push it down firmly. Afterwards
you can carefully remove the aid and click it back onto the laminate feet.
Attaching the Threshold Ramp to a raised edge/doorstep.
8
Determine where the 3 fastening screws will have to go and cut out the prepared openings.
9
Mark the location on the raised edge/doorstep, pre-drill and fasten the screw and washer. Do not
tighten them completely. Now place the SecuCare Threshold Ramp over the screw/washer.
10
The end result:
10