Installation And Assembly - Lacor 69420 Instrucciones De Uso Y Mantenimiento

Lámpara / calentador electrico
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 3
1.- Locate the unit at the proper counter height, in an area that is convenient for use. The
location should be level to prevent the unit or its contents from accidentally falling, and
strong enough to support the weight of the unit.
2.- Do not place anything on top of the heating lamp; doing so could damage the device or
subject personnel to possible injury.
3.- When setting up the unit for operation, make sure power to the unit is off. Failure to do so
could result in personal injury.
4.- Place the lamp in sufficiently spacious, indoor or outdoor areas, so as to avoid fire hazards,
excessive heat buildup, dizziness, or causing injury to others.
5.- Never use the heating lamp near wet areas such as baths, saunas...etc as it could cause
an electric stock.
6.- Never use near fuel tanks, gases, paint or any other flammable substance or substance
which could react to a short circuit
7.- Do not place anything on top of the reflector as it might burn, do not attempt to hang
clothes. Avoid direct contact with the lamp, always maintain a safe distance.
8.- Do not move the lamp while it's switched on, turn it off and unplug it before attempting to
move it.
9.- Never touch the lamp while it's switched on, or whilst still hot as it may cause severe burns.
10.- Do not remove the protective mesh on the lamp as this is essential to avoiding accidents.
11.- Even after switching the lamp off it will remain hot for several minutes, therefore do not
touch it..
12.- Avoid using the heating lamp on windy, or rainy days.
1.- Open the large box. Remove all packing materials and protective covering from the unit and
parts. Do not discard the wrapping until you have checked that the blender is working
correctly.
2.- The lamp comes with a chain, and ring to allowing it to be hung from the ceiling.
Do not hang it in any other position but horizontal, with the reflector on top.
3.- Make sure that the post or beam from which it will hang can support around about four times
the lamps' weight.
CAUTIONS

INSTALLATION AND ASSEMBLY

20

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

69421

Tabla de contenido