Cleaning And Maintenance - MaxPro MPBCO355 Manual Del Usuario

Tabla de contenido

Idiomas disponibles

Do not make cut off disc adjustments during the cut. Check that the bevel and depth adjustments are set

and secure before beginning.

Cut depth should always be set for no more than 3-6 mm larger than the thickness of the material to be

cut.

Always expose as little of the cut off disc as possible.

Important!

machine is protected against accidental starting by pulling the mains plug.

Repair and maintenance work on the electrical system may only be carried out by a qualified electrician.

A qualified repair technician must perform any tool service or repair. Service or maintenance performed

by unqualified personnel could result in injury. Use only identical replacement parts. Use of unauthorized

parts or failure to follow maintenance instructions may create a risk of electric shock or injury.

Consult a qualified repair shop if a malfunction or damage occurs to this tool, including cut off discs and

guards.

Cleaning:

Clean the machine regularly.

Some chemicals can damage the product. Do not use harsh chemicals like gasoline, carbon tetrachloride,

paint thinner etc.

Use only mild soap and a slightly damp to clean the tool. Never let water or oil into the inside of motor.

Make sure the motor fan and fan cover are also kept clear of dust.

Keep construction debris out of vents and triggers by blowing with compressed air. If compressed air is

unavailable, please use a soft bristle or brush.

All protective and safety devices must be re- attached immediately after completed cleaning, repair and

maintenance work.

Defective safety devices must be replaced immediately.

Motor carbon brushes:

The motor uses carbon brushes, which may require replacing. Carbon brushes wear out over time and

could create motor trouble. Regularly inspect brushes after 100 hours of use. Keep carbon brushes free and

clear of debris, and replace worn parts when necessary. Brushes are located on either side of cut off saw

motor.

- Unscrew the black plastic cap at the side of the motor and then remove the cap cautiously, because the

carbon brushes are spring loaded.

- Press the spring to release the carbon brushes.

- Take off each carbon brush check it and replace it if necessary. Replace both carbon brushes also if only

one is worn out.

- Position the carbon brushes in the motor.

- Screw the plastic cap back at the side the motor.

Run the machine for about 5 - 10 minutes to allow the carbon brushes to adapt to their position. If these

are not correctly assembled, the motor can be seriously damaged. While the carbon brushes adapt to their

position you can notice sparks coming out of the motor: this is normal for new carbon brushes.

All manuals and user guides at all-guides.com

Cut Off Saw MPBCO355 User Manual