GE Monogram ZDI15 Guía De Uso Y Cuidado página 15

Interior
1. Unplug the icemaker or disconnect power.
2. Open the storage bin door and remove any
3. Remove the drain cap from the water pan
4. Remove the three screws that hold the cutter
5. Unplug the wiring harness from the left side
6. Unplug the ice level sensor from the right
7. Remove the right-hand screw and loosen the
NOTE: Make sure the plastic spacer from the
right-hand side of the cutter grid bracket stays
with the cutter grid.
ice that is in the bin.
and drain thoroughly. Replace the drain
cap.
grid cover in place.
of the cutter grid.
Cutter
grid
cover
Screws
side of the cutter grid. Pull the ice level
sensor down and forward away from the
cutter grid.
left-hand screw. Lift the cutter grid up and
out over the left-hand screw.
Wiring
harness
OFF ON CLEAN
Screw
Cutter
grid
Ice level
sensor
Care and Cleaning
8. Remove the two screws that hold the water
pan in place. Push down with one hand on
the front of the pan while pulling forward
on the bottom back side.
9. The cutter grid, exterior of hoses, water pan,
storage bin, door gasket, and ice scoop
should be cleaned with mild soap or
detergent and warm water. Rinse in clean
water. Then clean the same parts with a
solution of 1 tablespoon (15 mL) of
household bleach in 1 gallon (3.8 L)
warm water. Rinse again thoroughly in
clean water.
NOTE: Do not remove hoses. Do not wash
plastic parts in dishwasher. They cannot
withstand high temperatures.
10. Wash only the outside of the plastic hoses
with mild soap or detergent and warm
water. Rinse with clean water.
11. Replace water pan by pushing back on the
bottom with one hand while pushing up
and back on the top. Secure the water pan
by replacing both screws.
12. Check the following:
•
Drain cap from the water pan is in place.
Screw
•
Hose from the water pan is inserted into
the storage bin drain opening.
13. Slide the cutter grid back into place and
secure it by replacing the right-hand screw
and tightening the left-hand screw.
Reconnect the electrical and ice level
sensor harnesses.
Plastic
14. Replace the cutter grid cover with three
spacer
screws.
15. Plug in the icemaker or reconnect power.
16. Reset the controls. See the "Set controls"
section.
Icemaker
15