Prestige APS-140 El Manual Del Propietario página 6

Transmitters Included With This Kit:
The transmitters are programmable and at times it may become necessary to replace trans-
mitters if they become broken or if they are stolen. If this is the case, order replacement
transmitters from Audiovox Customer Service @ 1800-645-4994. The transmitters packaged
with this kit are 140TX.
To Program new or replacement transmitters:
1. Enter the vehicle, and turn the ignition key to the "on" position.
2. Press and release the valet/override/program push button switch 3 times.
3. The dash LED will flash one time and the siren will "chirp" 1 time indicating the
system is ready to accept programming for channel 1Arm/Disarm, Lock/Unlock
and Panic.
4. Press and hold the lock button of the first transmitter until the parking lights flash and a long
chirp is heard from the siren
Repeat for each transmitter to be programmed. Note a maximum of 4 transmitters can be
programmed.
Turn the ignition switch off or allow 15 seconds of inactivity to exit the transmitter program
mode.
By completing the above, all three buttons of the transmitters are programmed into their
default location.
Lock = Lock / Arm, & Panic
Unlock = Unlock / Disarm & Panic
Trunk = Trunk Release & Panic Cancel, Press & Hold 2.5 seconds to release
trunk, Press while Panic Sounding cancel panic immediately.
Battery Replacement:
Use CR2032 or equivalent.
1) Using a 0 Point Phillips Screwdriver, remove the screw from the back of the case where
indicated by the arrow.
2) Carefully separate the top case from the bottom.
3) Slide the discharged battery from under the clip in the direction shown.
4) Properly dispose of the discharged battery.
5) Replace with a new CR2032 or equivalent battery.
6) Carefully align and snap closed the transmitter case.
7) Reinstall the screw removed in step #1.
Page 6
128-8205
6 of 16