Switch
System identification button
Enclosure mode switch
Password reset switch
Power Supplies
AC power supply (per power supply)
Wattage
Voltage
Heat dissipation
Maximum inrush current
Available Hard Drive Power (Per Slot)
PowerVault MD3200
PowerVault MD3220
RAID Controller Module Power (Per Slot)
Maximum power consumption
Physical
PowerVault MD3200
Height
Width
Depth
16
Getting Started With Your System
All manuals and user guides at all-guides.com
Located on the front control panel.
This button is used to locate a system
within a rack.
Located on the front of the system.
This switch is not applicable to the
PowerVault MD32xx RAID enclosure.
Located on the back-panel of the RAID
controller module. This switch is used to
reset the storage array password.
600 W
100–240 VAC (8.6 A–4.3 A)
100 W
Under typical line conditions and over the
entire system ambient operating range,
the inrush current may reach a maximum of
55 A per power supply for 10 ms or less.
25 W
12 W
100 W
8.68 cm (3.41 inches)
44.63 cm (17.57 inches)
60.20 cm (23.70 inches)