Important Safeguards - Sunbeam STEAM MASTER 4055 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFEGUARDS

When using your S
S
®
UNBEAM
TEAM
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
1. Use iron only for its intended use.
2. To protect against risk of electric shock, do not immerse the iron in water
or other liquids.
3. The iron should always be turned to "OFF" before plugging or unplugging
from outlet. Never yank cord to disconnect from outlet; instead, grasp plug
and pull to disconnect.
4. Do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Loop cord loosely around iron when storing.
5. Always disconnect iron from electrical outlet when filling with water
or emptying and when not in use.
6. Do not operate iron with a damaged cord or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble the iron.
Take it to a qualified service technician for examination and repair.
Incorrect reassembly can cause a risk of electric shock when the iron is used.
7. Close supervision is necessary for any appliance being used by or near children.
Do not leave iron unattended while connected or on an ironing board.
8. Burns can occur from touching hot metal parts, hot water or steam.
Use caution when you turn a steam iron upside down – there may be
hot water in the reservoir.
9. If your S
M
®
is not operating normally, disconnect from the
TEAM
ASTER
power supply and have the flatiron serviced by qualified service personnel.
10. Your S
I
is designed to rest on the heel rest. Do not leave
®
UNBEAM
RON
the iron unattended. Do not set the iron on an unprotected surface,
even if it is on its heel rest.
All manuals and user guides at all-guides.com
M
I
, basic safety precautions
®
ASTER
RON
2
S
P E C I A L
1. This is a 1200-Watt appliance. * To avoid a circuit overload, do not operate
another high wattage appliance on the same circuit.
2. If an extension cord is absolutely necessary, a 10-Ampere cord should be used.
Cords rated for less amperage may overheat. Care should be taken to arrange
the cord so that it cannot be pulled or tripped over.
SAVE THESE INSTRUC TIONS
FOR PRODUCTS PURCHASED IN THE U.S. AND CANADA ONLY
To reduce the risk of electrical shock, this appliance has a polarized plug
(one blade is wider than the other). This plug fits a polarized outlet only one way;
if the plug does not fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to defeat this safety feature.
*
In Mexico, the iron runs at 127 Volts, 1350 Watts. If an extension cord is necessary,
a 13-Ampere cord should be used.
I
NSTRUC TIONS
3

Publicidad

Tabla de contenido
loading

Tabla de contenido