Mounting The Microphone - Behringer C-1U Manual Del Usuario

24 C-1U User Manual
1. Directivity
Your C-1U features a capsule with a cardioid pickup pattern and is ideal for recording individual
instruments, vocals and speech. Cardioid pickup pattern means that the sound produced by
sources located in front of the mic is strongly picked up. It is often used in recording situations,
since this directivity pattern tones down the pickup of sounds located to the back of the
microphone.
To place the microphone correctly, the Behringer logo needs to face the sound source being
recorded.

2. Mounting the Microphone

There is an adapter on your microphone that lets you mount it on mic stands with either metric
(Europe) or imperial-gauge threads (North America). First dismantle the microphone from the
stand mount adapter by detaching the fine-thread shoulder screw at the bottom end of the
microphone. Fasten the adapter onto the microphone stand, place the microphone into it and
tighten the screw again.
Basically, the microphone in the stand mount adapter should stand upright and face the sound
source at a right angle. The angle of the microphone to the sound source influences the sound
of the recording; therefore, experiment with different positions until you achieve the desired
sound. To this end, you can rotate the mic in the stand mount adapter by loosening the screw
somewhat and tightening it again.
If necessary, you can bend the microphone out of its vertical position by using the hinge on the
microphone stand.
◊ ◊
Please make sure to handle the microphone shaft with attention and care to avoid
damaging the screw thread. In no situation should you ever apply excessive force.
Of course, you can detach the C-1U from the stand mount adapter and attach it to a
commercially available suspension mount.