Assembly; Operation - Ryobi P727 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious
injury or vision loss.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is suf-
ficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of at-
tachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 General illumination of most work area spaces.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 7.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

NOTE: The battery pack should be recharged after
approximately 5 hours of use to reduce the possibility of
damage. Repeated deep discharge of the battery may
decrease storage capacity and battery life.
TURNING THE WORKBENCH LIGHT ON/OFF
See Figure 2, page 7.
 Mode 1: Press the ON/OFF button to turn the light on.
NOTE: This will turn on both the upper and lower portion
of the workbench light.
 Mode 2: Press ON/OFF button 2 times to turn off the
upper portion of the workbench light.
 Mode 3: Press ON/OFF button 3 times to turn on
the upper light and turn off the lower portion of the
workbench light.
 To stop the workbench light, press the ON/OFF button
4 times.
WARNING:
Battery tools are always in operating condition. Therefore,
unit should always be in the OFF status, with the battery
pack removed, when not in use. Do not leave light on
while unattended. Failure to follow these instructions
could result in serious personal injury.
WARNING:
Keep workbench light away from combustible materials.
If wrapped or in contact with fabrics, the work light lens
can produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the work light lens to
come in contact with anything.
5 – English